Use the Line tool (
) in SketchUp to draw edges, also called line entities. Connect edges to form a closed plane and create a surface. Combine surfaces to build a model.
In SketchUp for iPad, the Line tool has 5 optional tool modes. Each mode locks drawing to a linear inference. The 5 optional tool modes are:
- Lock to X (
) locks line drawing to the X/Red axis. - Lock to Y (
) locks line drawing to the Y/Green axis. - Lock to Z (
) locks line drawing to the Z/Blue axis. - Lock Parallel (
) makes the next line parallel to a selection or the last line drawn. - Lock Perpendicular (
) makes the next line perpendicular to a selection or the last line drawn.
To learn or review drawing basics and inferencing, read Introducing Drawing Basics and Concepts.
Input methods
Select the Line tool and activate any optional tool mode you need. You can then draw using any of these iPad input methods:
Note: Activate any optional tool mode before you start drawing your lasso.
Pencil uses the Line tool differently depending on the Pencil mode:
- Click-Move-Click. Place the Pencil where you want the line to start. Press until a ring with an arc appears. When the arc turns green, drag or move the Pencil to the endpoint. Tap the Pencil there to draw the line.
- Just Draw. Place the Pencil where you want the line to start. Drag or move it to the endpoint. Lift the Pencil to draw the line.
Double tap the Pencil to cancel while drawing or to start a separate line.
In either Pencil mode, dragging the Pencil while drawing may change the line colour to match the drawing axis. You may also see inference points from other items in your model. These inferences do not appear if you lift the Pencil and move it to the endpoint.
Multitouch. Long press where you want the line to start. Drag your finger to the endpoint. Lift your finger to draw the line. Use a two-finger tap to cancel while drawing or to start a separate line.
Dragging your finger while drawing may change the line colour to match the drawing axis. You may also see inference points from other items in your model. These inferences do not appear if you lift your finger and move it to the endpoint.
Touchpad/Mouse. Press or click and hold where you want the line to start. Drag to draw the line, then release the touchpad to set the endpoint. The line colour changes to match the drawing axis, and inference points appear from other items in your model.